Setting the loop


Please turn ON the Loop field.
Adjustment of a loop point

Please move cursor to the loop field and adjust a loop point.

Adjustment of an end point

Please move cursor to Endfield and adjust an end point.

Note
It is required 256 points or more between the end point of a loop, and the end point of a sample.
When the end point of a sample is the same as the end point of a loop, a noise arises.




If the [WINDOW] button is pressed when a loop field is ON, the window of "Loop" will open.

The left of screen is an end point and the right is a loop point.
Please turn and adjust a DATA wheel.
Level is expanded and displayed by cursor button.

Zero crossing point
If F2 ( Zcross) button or F3 (Zcross ) button is pressed, it will be automatically set to a zero crossing point (wave-like amplitude is a point of 0).
If F2 ( Zcross) button is pressed, in search of the zero crossing point of the direction of the left, it will set automatically.
If F3 (Zcross ) button is pressed, in search of the zero crossing point of the direction of the right, it will set automatically.


If F3 (Zcross ) button is pressed in the state of the above figure, a result of the following figure will be brought.


If cursor is moved to the End field and F2 ( Zcross) button is pressed, a result of the following figure will be brought.






selecting Loop mode
Please move cursor to the loop mode field and select by a DATA wheel.

Forward loop

From a loop point to between end point, playback is repeated to forward direction.

Alternate loop

From a loop point to between end points, playback is repeated for a forward direction/reverse direction alternately.

Crossfade loop

Crossfade loop. (Crossfade of a start and end of a loop is carried out.)
Note: The short loop of 100mSEC or less cannot carry out cross fade.
If F5 (X to) button is pushed, the window of "Convert X-fade to Normal loop" will open.


If F4 (DO IT) button is pressed, a cross fade loop will be converted to a normal loop (forward loop).
As for the sample of a cross fade loop, two voices are used. (As for a stereo sample, four voices are used)
A voice can be reduced to one by converting to a normal loop. (The stereo sample can reduce a voice to two)

Linking the loop point to the start point

Please move cursor to field.
Turn the DATA wheel and set the field to (locked by the key).


A loop point becomes the same value as a start point, and a start point will also be changed into the same value if a loop point is changed.
A loop point will also be changed into the same value if a start point is changed similarly.
Please reset to(unlocked by the key) to set a loop point and a start point separately.

A loop point can be adjusted with the length of a loop held.


Please move cursor to the "End" field, turn a DATA wheel, and select "Len".


Please move cursor to the loop field.


A loop point can be adjusted holding the length of a loop, when the DATA wheel was turned.




The length of a loop can be adjusted if a DATA wheel is turned in the Len field.