AUDIO TRACK

If arbitrary trucks are chosen and Type is chosen as "AUDIO" in the Type field, the truck can be used as an audio track. (A maximum of 32 tracks, MONO)



Playing back a Sample


Please move cursor to the sample field.
Please select a sample to playback by a data wheel.
Selection of a sample can also be select from the window of "Sample list".
Playback of a sample will be begun if [PLAY] or the [PLAY START] key is pressed.
When the [PLAY] key is pressed, playback can be begun from the present time.

Press the [STOP] key. will stop playback.

Press the [WINDOW] key. The "Sample list" window will open.



It is a playback start by the PLAY START key.

Stops by 00
5.04.24

If the PLAY key is pressed, playback will be begun from 005.04.24.


When cursor is a FX field, press the [WINDOW] key, the "EFFECTT" window will open.



Note
In the case of a stereo sample, only the wave of L is displayed.


Start offset of a sample


A sample can be started from arbitrary positions.
Example of a setting

It sets up start from 006.01.00.
A sequence is started by the [PLAY START] key.
If a sequence comes to the position of 006.01.00, reproduction of a sample will start.




PAD LOCATE


Arbitrary locations are memorizable to pads.
Please move cursor to a location to memorize, and press a [SHIFT] + PAD.
In the case of the above figure, if [SHIFT] + PAD7 is hit, the present cursor location will be memorized to PAD7.


If PAD7 is hit, cursor will move to the position memorized by the pad.
If a pad is hit from the state of a stop, it will play from the location memorized by the pad.
A memorizable pad is to PAD7-PAD16.


Notes:
Performance using "PAD LOCATE" cannot be recorded.

Moreover, as shown in the following figure, the function is assigned to PAD1-PAD6. (Does not work during recording)


Preparing the recording


Please move cursor to the track field and press the [WINDOW] key, the window of "Record setups" will open,


Starting the recording


When the [REC]+[PLAY START] key is pressed, recording is started from 001.01.00.

When the [REC]+[PLAY] key is pressed, recording is started from the present position and the present position is set to START field.

From 00
3.01.00 to a recording start


003.01.00 is automatically set to START field.

Notes
When the loop of a sequence is ON, recording is automatically stopped at the end of a sequence.
When a loop is OFF, the recording will continue until you press the [STOP] key.
And the number of the bar when you actually pressed the [STOP] key will be set as the new length for the sequence.
[OVER DUB] key does not work.
Moreover, it cannot go to other screens during recording.
Movement of cursor cannot be performed, either.
The program has the parameter of Q-Link.
There is no program in an audio track.
Therefore, Q-Link does not work in an audio track.
Audio track is can not convert in song mode.