PLAY MODE	ONE SHOT	The MPC plays the sample until the end regardless of how long you hold the pad.
	NOTE ON	The MPC plays the sample only while you hold the pad.
	LOOP&HOLD	Loop playback of the sample is carried out, and it repeats until a pad is hit once again. (loop hold playback) Notes When the Play field is set to MONO, it does not work normally. Loop hold playback works to ON/OFF of pads, and ON/OFF of notes. Therefore, it does not work to ON/OFF of the recorded notes. Moreover, loop hold playback is recorded as duration. As for the sample to which the loop is set, the loop hold playback will be done from the loop point to end point. As for the sample to which the loop is not set, the loop hold playback will be done from the start point to end point. S.START of Q-Link, S.END, and CHOP do not work to the sample by which loop hold playback is performed.
VOICE	It opts for the behavior when pronouncing the same note during a release.
	POLY	The sound during release pronounces a new note, without erasing.
	MONO	The sound during release is erased and pronounces a new note.

VELO (The curve of volume against velocity is determined.)

When this value is low, by a velocity, volume is wide range changes.
When this value is high, by a velocity, volume is narrow range changes.
When this value is 100, it always becomes the same as a velocity 127.


A---(Attack) Time until it reaches the maximum volume of the sound from NOTE ON is set.

D---(Decay) Time until it shifts to a Sustain level from the maximum volume which reached with the Attack is set.

S---(Sustain) After Decay finishes, the volume pronounced as long as sound is sounding is set.

R---(Release) Time until sound finishes sounding from NOTE OFF is set.

As shown in the following figure, when a sample is ONE SHOT, "Release" works.