OUT FX(INST)

The output destination of a sample, the effect to be used, etc. are set up.


Notes: The sequence memorizes the setups (value of parameters) of the track mixer.

LVEL: Please set an output level.
PAN: Please set the value of PAN.
OUT: Please set the output destination.
ST is outputted to STEREO OUT.
1-4 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC1000)
1-8 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC2500)
L is outputted to L of STEREO OUT and R is outputted to R of STEREO OUT. (Selection only in MPC1000)
FX: Please set, when you apply an effect.
OFF: Don't use an effect. (However, the effect of a master is applied. When EQ and COMP are ON)
FX1: The effect selected by FX1 is applied.
FX2: The effect selected by FX2 is applied.
Note: Selection is possible only when ST is select in the OUT column.
SEND: Please set the amount that an effect is applied to. (It can set, only when REVERB or DELAY is select with the effect.)

Notes
A sequence memorizes a setup of a truck mixer.
Therefore, if a setup of a truck mixer is changed, please save a sequence.

MASTER
EQ		 The equalizer of a master is applied when it is ON.
MASTER
COMP		 The compressor of a master is applied when it is ON.
FX1,FX2 Please select the effect to be used.
MIDI-CC to FX2 Edit When you operate the value of the parameter of FX2 by a MIDI controller, please turn ON.
Refer for the method of a setup of a controller here.