The output destination of a sample, the effect to be used, etc. are set up.

Notes: The sequence memorizes the setups (value of parameters) of the track mixer.

LVEL:	Please set an output level.
PAN:	Please set the value of PAN. The value of pan of the pad and track is mixed. For example, the value of the pan of a track is R50. The value of pan of a pad is set to MID when the value of pan of a pad is L50.
OUT:	Please set the output destination. ST is outputted to STEREO OUT. 1-4 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC1000) 1-8 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC2500) L is outputted to L of STEREO OUT and R is outputted to R of STEREO OUT. (Selection only in MPC1000) The setting of the track mixer will be referred to for OUT when TRK is set. [MODE]+PAD8(MIXER)
FX:	Please set, when you apply an effect. OFF: No effect will be used. (The effect of a master is applied. However, when EQ and COMP are ON) FX1: The effect selected by FX1 is applied. FX2: The effect selected by FX2 is applied. Note: Selection is possible only when ST is select in the OUT column.
SEND:	Please set the amount that an effect is applied to. (It can set, only when REVERB or DELAY is select with the effect.)

Notes
A sequence memorizes a setup of a truck mixer.
Therefore, if a setup of a truck mixer is changed, please save a sequence.