Recording a sample


If F3 (REC SETUPS) button is pressed, the window of "Record setups" will open.
Please set if needed.




If the [REC]+[PLAY START] button is pressed, recording will be started from 001.01.00.
Recording will be stopped if the [STOP] button is pressed.

The state which has a marker in a bar 3

When the [REC]+[PLAY] button is pressed in the state of the above figure, recording is started from the bar of a current position.


A stop of recording will input automatically into the Bar field the bar with which the marker was located at the time of a start.
And recorded sample"Take01" is assigned to a bar.



Notes
When the loop of a sequence is ON, recording is automatically stopped at the end of a loop.
When the loop of a sequence is OFF, the recording will continue until you press the [STOP] button.
And the number of the bar when you actually pressed the [STOP] button will be set as the new length for the sequence.
[OVER DUB] button does not work.
Moreover, it cannot go to other mode during recording.
Change of a track cannot be performed, either.