| Input Thru |
If
the INPUT THRU button is pressed, INPUT THRU
mode will be displayed.
The MPC2500 can mix the incoming signal from RECORD IN or DIGITAL
IN with the play back sound from the MPC2500.
You can also route the Input Thru signal to the internal Effects
and Filters.
Note
If INPUT THRU is turned ON, two voices will be used for
processing. (It is one voice when L or R is select by MODE.)
The value of a parameter can be set with a DATA
wheel or Q1 slider.
Note: When cursor is in the
TYPE field, the value of FREQ will be changed if Q1 slider is
operated.
| Level meter | The level of an
incoming signal is displayed. Please perform adjustment of level by the [REC GAIN] knob. (It cannot adjust, when Sourec is DIGITAL) |
| Sourec | You can select the input signal, ANALOG or DIGITAL. |
| MODE | You can select
the input signal, ST (Stereo), L (L channel) or R (Right
channel). Please choose LR to use L and R by a separate set. |
| TYPE | The type of the
filter to be used is select. LPF(LOW PASS): This filter cuts out the high frequencies and passes the low frequencies. BPF(BAND PASS): The filter passes the specific frequencies and cuts out the other frequencies. HPF(HIGH PASS): This filter cuts out the low frequencies and passes the high frequencies. LNK(Filter2): The always same setting as a filter 1 is applied. |
| FREQ | Please set the cut off frequency. (0-100) |
| RESO | If you set the resonance value at a larger value, the frequencies set in the Freq field will be boosted more. (0-100) |
| LEVEL | Please set the level of a signal. (0-100) |
| PAN | This will allow
you to set the pan position. (L50 - MID - R50) Note: When STEREO is chosen in the MODE field, it cannot set. |
| OUT | Applying effects to an You can select the outputs of the input thru signal. (ST, 12, 34, 56,78,1, 2, 3, 4, 5, 6,7,8) |
| FX | You can select
the effect of the input thru signal. (OFF, FX1, FX2) Note: Selection is possible only when ST is select in the OUT field. |
| SEND | You can set the
effect send level of the Input thru signal. (0-100) It can set, only when REVERB or DELAY is select with the effect. |
Recording
If the [REC] button is ressed, the sound of MAIN
OUT will be recorded.
If [STOP] or the [REC] button is pressed once again, recording
will stop. (Even if it changes a screen, recording stops.)
If recording is stopped, the recorded contents will be kept to
the memory of MPC by the file name of "Sample**".