-Following feature was deleted.-
Pressure setting in Main screen
PATTERN
Cycle
Pads status display mode
-Change and the added feature-
1. Addition of a simul sequence. (Refer to manual.)
2. Pattern creation mode is added to [MODE]+PAD11. (Refer to video.)
3. Non-Destructive Chop was added. (A setup of chop of OS2XL is also reflected) (Refer to video 128XL.) (Refer to video OS3.)
4. A setup of a chord can be saved as a file. (Contents memorized to the flash memory can be made a file, and can be saved.) (Refer to video.)
5. "PgmMode" of trim is now possible with INST program as well. (Refer to video.)
6. Swing field is added to GRID. (It is not effective against the recorded event. Same as OS2XL)
7. [808] buttons are added to GRID. (Refer to video.)
8. F1 button of the main screen and grid was changed into "LOOP". (Refer to video.)
9. A slider can be used on the screen of a trim and a mixer.
10. F1 of the audio track was made into "CUE", F2 was made into "SetBars", and the feature assigned to the pad was changed. (Moreover, only 128 XL adds Q-Link) (Refer to video OS128XL) (Refer to video OS3)
11. Specification of loop edit of a grid was changed.
12. The feature in pad mode moved to the "Pad to MIDI out" window. (Refer to manual.)
13. Changed the maximum value of Hold of AMP to 200. (1-100 1=10msec 101-200 1=1bar) (Refer to video.)
14. Changed the maximum value of Attack of PITCH to 135. (Refer to video.)
15. MIDI-CC button was added to the mixer of a track and a pad.(OS3) (Refer to video.)
16. Display of a splash screen is added to a test mode. (Refer to video OS128XL) (Refer to video OS3)
When a pattern file is loaded by Ver.2.0, it is converted as a sequence. (Refer to video.)
The list of pattern names converted when the track 2 was chosen by step editing can be seen.
