AMP| AMP FILTER |
AMP
| VOICE | It opts for the behavior when pronouncing the same note during a release. | |
| POLY | The sound during release pronounces a new note, without erasing. | |
| MONO | The sound during release is erased and pronounces a new note. | |
| PRIO (Priority) |
If this parameter is turned ON, even if voices will become less , the sound of this pad will not be interrupted. | |
| ATK (Attack) |
Time until it reaches the maximum volume of the sound from NOTE ON is set. | |
| DCY MODE (Decay) |
 |
The start point of the decay will be set so that thefade out will end at the sample's end point |
 |
The decay will begin right after the attack time set in the Attack (Higher values cause slower decay) | |
FILTER
| TYPE | Please select the kind of filter. |
| LPF(LOW PASS): This filter cuts out
the high frequencies and passes the low frequencies. BPF(BAND PASS): The filter passes the specific frequencies and cuts out the other frequencies. HPF(HIGH PASS): This filter cuts out the low frequencies and passes the high frequencies. EQL(Equalizer Low): Low sound is boost and cut. EQH(Equalizer High): High sound is boost and cut. |
|
| FRQ (Frequency) | Please set the cut off frequency. (0-100) |
| RESO (Resonance) | If you set the resonance value at a higher value, the frequencies set in the FRQ column will be boosted more. (0-100) |
| DEPTH | Quantity whose effect of Attack and
Decay to a filter is effective. When this is OFF, Attack and Decay does not work. |
| ATK (Attack) | Time until reaching the value of NOTO ON to DEPTH is set. |
| DCY (Decay) | Time until it decreases from the value of DEPTH which reached by Attack is set. |