| AMP |
| VOICE | It opts for the behavior when pronouncing the same note during a release. | |
| POLY | The sound during release pronounces a new note, without erasing. | |
| MONO | The sound during release is erased and pronounces a new note. | |
| PRIO (Priority) |
If this parameter is turned ON, even if voices will become less , the sound of this pad will not be interrupted. | |
VELO (The curve of volume
against velocity is determined.)
When this value is low, by a velocity, volume is wide range
changes.
When this value is high, by a velocity, volume is narrow range
changes.
When this value is 100, it always becomes the same as a velocity
127.
A---(Attack) Time until it reaches the maximum volume of the
sound from NOTE ON is set.
H---(Hold) Hold time in a peak state of sound (1=10msec) Ver.2.xx(1-100
1=10msec 101-200 1=1bar)
D---(Decay) Time until it shifts to a Sustain level from the
maximum volume which reached with the Attack is set.
S---(Sustain) After Decay finishes, the volume pronounced as long
as sound is sounding is set.
R---(Release) Time until sound finishes sounding from NOTE OFF is
set.
As shown in the following
figure, when a sample is ONE SHOT, "Release" works.
