The output destination of a sample, the effect to be used, etc. are set up.

Note: The sequence memorizes the setups (value of parameters) of the track mixer.

STREO:	The sample of a stereo can be switched to a mono. Mono of only L or R and mono of L+R can be select. The number of the voice used even if it switches to mono is the same.
LVEL:	Please set an output level.
PAN:	Please set the value of PAN. The value of pan of the pad and track is mixed. For example, the value of the pan of a track is R50. The value of pan of a pad is set to MID when the value of pan of a pad is L50.
OUT:	Please set the output destination. ST is outputted to STEREO OUT. 1-4 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC1000) 1-8 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC2500) FX1: The effect selected by FX1 is applied to STEREO OUT. FX2: The effect selected by FX2 is applied to STEREO OUT. The setting of the track mixer will be referred to for OUT when "Trk" is set. [MODE]+PAD8(MIXER)
SEND:	Please set the amount that an effect is applied to. (It can set, only when REVERB or DELAY is select with the effect.)

Notes
A sequence memorizes a setup of a truck mixer.
Therefore, if a setup of a truck mixer is changed, please save a sequence.
When setting OUT to 7 or 8, do not set a filter (same for Q-link and LFO filters) on all tracks. (MPC2500)
If a filter is set, the sound will be distorted.

FX

Note
There is no effect set select.