| SAMPLE |
| PAD: | The pad number is displayed. | |
| SAMPLE: | The sample assigned to a pad is set. | |
| DIR: | The playback direction of
a sample is select. "FOR" is played back to a forward direction. "REV" is played back to an reverse direction. |
|
| TUNE: | The pitch of a sample is set. (+ /- 3 octave can be set.) | |
| PLAY MODE: | ONE SHOT | The MPC plays the sample until the end regardless of how long you hold the pad. |
| NOTE ON | The MPC plays the sample only while you hold the pad. | |
Auto chromatic assignment. (PAD
of the cursor position is set to TUNE 00.00, and the value of
TUNE is fluctuated 01.00 (half tone) every.)
For example, when you want to use one sound, making it into a
chromatic scale
Please choose the sample which makes a chromatic scale in the
SAMPLE column.
If [SHIFT]+F5 (CHROM.) button is pressed, PAD of the cursor
position will be set to TUNE 00.00, and the value of TUNE will be
fluctuated 01.00 (half tone) every. (A maximum of +/- 3 octave)
If [SHIFT]+F5 (CHROM.) button is pressed in the case of the above
figure, the result of the following figure will be obtained.
PAD of A06 is set to TUNE 00.00, and the value of TUNE is
fluctuated 01.00 (half tone) every.
A05-A01 is minus 01.00 (half tone) every, and A07-C10 is plus 01.00
(half tone) every.
In addition, if [SHIFT]+F4 (ClrTUNE) button is pressed, the value
of TUNE of all the PAD will be set to 00.00.
STRT/END
(Setting the sample start and end points)
If a DATA wheel is turned in STRT or an END column or
the WINDOW button is preesed, the window which adjusts a start
and end point of a sample will open.
When a sample is a stereo, the waveform of L channel is
displayed.
Please turn ON the Use St./End field and adjust a start
and an end point.
If adjustment finishes, please press F6 (CLOSE) button
and close a window.
A value is displayed on STRT and an END column.
The value here is displayed as a percentage
If a window is opened, the Use St./End field is turned
OFF and a window is closed, it will return to the state before
adjustment.
A start point can be changed holding length, when F5 (Len
End) button was pressed and "Len" was select.
Please move cursor to St. field and adjust a start point.
The range of a highlighting moves holding length, when
the start point was changed.
