If MIDI is chosen in the type field, it will become the grid mode of MIDI.

Basic operation is the same as a DRUM grid.
However, region selection of edit is only horizontal.
The range of a note cannot be chosen.

Edit of PITCH BEND, CONTROL CHANGE, CHANNEL PRESS, POLY PRESS


If [SHIFT] + F1 (CC/BEND) button is pushed, it will become the edit mode of PITCH BEND, CONTROL CHANGE, CHANNEL PRESS, and POLY PRESS.


Please press cursor button and move cursor to the parameter field. (In the case of OS3, please press the cursor key.)


Please select the parameter which you want to edit or enter.

Entering an event

Please turn on LED of [OVER DUB] and move a marker to the position into which you want to enter an event.

Please enter an event by Q1 and Q2 slider.


Other events are not erased even if it entered an event into real time, recording.
When you want to edit an event, please move a marker onto an event to edit, and change a value by a slider.

If AUTO is used, two or more events can be entered at the same time.

Please select the region which enters an event by holding F5 (AUTO) button and turning a DATA wheel.


A default value will be entered if F5 (AUTO) button is released.


Please set the value of a start with Q1 slider.
Please set the value of a end with Q2 slider.


The record of an event will be completed if F6 (ENTER) button is pressed.


About the method of copy and paste, it is the same as a DRUM grid.
However, region selection of edit is only horizontal.
Moreover, although the method of a CUT is the same as ERASE, the cut event is copied to a clipboard.