INSERT SILENCE
The silence of the set time is inserted from a start point.
In the case of the above figure, the silence of 100mSEC is
inserted from the start point.
BIT
CONVERT
A sample can be converting into the sound of 4-12 bits.
If F1(PLAY) button is pressed, the audition of the present set
value can be performed.
If F2 (OVER W) button is pressed, an overwrite conversion will be
carried out with the set value.
If F3 (ALL) button is pressed, the overwrite conversion of all
the samples will be carried out with a set value.
Note: File size does not
change after convert.
RING
MODULATION
The output of 2 oscillators is mixed and a metallic sound is made.
If F2 (PLAY) button is pressed, the audition of the present set
value can be performed.
| Frequency: |
100Hz-5000Hz |
| WAVE : |
 Sine, Square. |
| Mix: |
1-10
The ratio to an original sound is set.
An original sound becomes 90% when 1 is set.
The sound for which the effect was adapted becomes 10%.
When 10 is set, it becomes only the sound for which the
effect was adapted. |
COMBINE
Two samples are combined.
When a noise is in joint, please set the "Fade A>Out-B<In"
field to ON.
Note: When TUNE is set to
the sample, it is set up with the value of Sample A.
MIX
Two samples are mixed.
Please adjust LEVEL if needed.
If F2 (PLAY) button is pressed, the audition of the mixed sample
can be performed.
The sample to which TUNE is set sounds by TUNE 00:00.
The sample of ON of a loop sounds by Loop OFF.
Notes
The sample to which TUNE is set is mixed as TUNE 00:00.
The sample of ON of a loop is mixed as OFF.
A Patched Phrase sample is unmixable.
INVERT
A waveform is inverted.
Next
page