Notes: The sequence memorizes the setups (value of parameters) of the track mixer.
Please move cursor to the field to set a value to, and turn and set a DATA wheel.
Q1 slider can adjust the value of pan. (MPC2500 is Q3 knob)
Q2 slider can adjust the value of level. (MPC2500 is Q1 slider)
In addition, the value of pan of the pad in the same track and pan of a track is mixed.
For example, the value of pan of a pad is set to L50.
When the value of pan of a track is set to R50, the value of pan of a pad is set to MID.
Note: When level and pan is operated with a slider, It cannot be operated if the position of a slider does not exceed the present set point.
PAN field
Please set the value of PAN.
OUT field
Please turn DATA wheel and set the output destination.
ST is outputted to STEREO OUT.
1-4 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC1000)
1-8 is outputted to ASSIGNABLE MIX OUT. (in the case of MPC2500)
L is outputted to L of STEREO OUT and R is outputted to R of STEREO OUT. (Selection only in MPC1000)
Note: As for the pad with which OUT of the pad is not set as TRK, OUT of a pad will be referred to. Refer to "OUT FX".
FX field
Please set, when you apply an effect.
Only the pad with which OUT of the pad is set to TRK is applied. Refer to "OUT FX".
OFF: No effect will be used. (The effect of a master is adapted. However, when EQ and COMP are ON)
FX1: The effect selected by FX1 is adapted.
FX2: The effect selected by FX2 is adapted.
Note: Selection is possible only when ST is select in the OUT field.
SND field
Please set the amount that an effect is applied to. (It can set, only when REVERB or DELAY is select with the effect.)
If a pad is struck holding the [SHIFT] button, two or more tracks can be chosen. (PAD1-PAD16 correspond to Track1-Track16.)
Moreover, 16 tracks can be chosen if a [SHIFT]+[PAD BANK] button is pressed.
[SHIFT]+BANK A = TRACK1-16
[SHIFT]+BANK B = TRACK17-32
[SHIFT]+BANK C = TRACK33-48
[SHIFT]+BANK D = TRACK49-64
If the [WINDOW] button is pushed when cursor is in level, PAN, and the OUT field, the window of "Track list" will open.
If the [WINDOW] button is pushed when cursor is in FX field, the window of "FX" will open.
If the MIDI field is turned ON, a MIDI controller can adjust LEVEL, PAN and SEND
A track is controllable only to track1-16
Moreover, when this is ON, the level of a MIDI sequence and the value of a pan are also reflected.
A channel and the control change number are as follows.
Note: Change of a channel or a control change number cannot be performed.