A start/end of a
sample can be adjusted by a program mode.In OS128XL Ver.2.xx, please refer to Non-Destructive Chop (OS128XL Ver.2.xx)
In OS3 Ver.2.xx, please refer to Non-Destructive Chop (OS3 Ver.2.xx)
If F1 button is pressed when F1 button is "SAMPLE1", it will change to the screen of "SAPLE2."
If F1 button is pressed once again, it will return to the screen of "SAMPLE1."
ALL and multiple selection cannot be performed on the screen of "SAPLE2."
Please move cursor to the START field and turn ON the START field.
Please move cursor to the right and adjust a start point by a DATA wheel.
Please move cursor to the END field and adjust an end point by a DATA wheel.
When the START field is ON, from the set start point to an end point is played back.
When the START field is OFF, from the start point of a sample to an end point will be played back.
Two or more starts / ends which are different with the same sample as shown in the above figure can be set.
If a BAR>> button is pressed, a waveform will zoom in.
If a <<BAR button is pressed, a waveform will zoom out.