| Loading method |
Top electrodes: Automatically pick from the loading tray. About 135 sheets (assuming 0.2 mm thickness for a sheet) can be loaded to the tray.
Bottom electrodes: Manually load on to the hotplate by user. |
| Unloading method |
Automatically unload completed modules to the unloading tray. Tray can hold about 70 modules (assuming 0.4 mm thickness for a module). User should clear the tray before overflowing it. |
| Electrode pick-up method |
Vacuum pads (4). Recommended maximum service temperature of rubber pads are 200°C.
(Manufactures absolute maximum service temperature is 230°C) |
| Vacuum levels for weight blocks and flexible electrode sheets |
For weight blocks: Full vacuum level of the pump
For flexible electrodes: Vacuum level can be lower until electrode deformation disappear by rotating 2 flow-control valves. |
| Size of electrodes (mm) |
100 × 100 |
| Number of pile-up locations on the hotplate |
4 |
| Top electrode aligning method |
Pre-determind position on the bottom electrode.
(User can change the offset distance of 2 electodes in the program) |
| Positioning accuracy of robot ( μm) |
±5 |
| Weight block size (mm) |
100 × 100 |
| Weight block thickness |
0.1 – 15 mm (User can change the value in the program) |
| Maximum weight of the block |
1.2 kg |
| Supported electrode thicknesses (mm) |
0.05 - 5 |
| Normal operation temperature of hotplate |
150 C |
| Maximum recommended hotplate temperature |
230 C |
| PC interface (for modifying programs) |
RS-232, (USB to RS-232 converter will be supplied) |
| Power Supply |
100 V AC, 50/60 Hz |
| Dimensions (W × D × H) (mm) |
500 × 710 × 568 |
| Weight |
35 kg |
